! parameters for primary angle sampling(-> --------------------------------------------------- complex *16 CosZenith !1 Range of cos(zenith angle). Say,(0.5, 1.0). Used when Za2ry is 'is' ! If ObsPlane=3(spherical), real(CosZenith) must be $> $0, and means ! the zenith angle range at the incident point(not in Exyz system). ! In that case, azimuth is 0 to 2pi. complex *16 Azimuth !1 Range of azimuthal angle in deg. Say,(0, 45). Default is(0, 360). ! Can be such as(300., 390.). Used when Za1ry is 'is'\newline ! If ObsPlane=3(spherical), this is used to show the half opening angle ! range where the primary injection position is uniformly distributed ! on a sphere. The center of the opening angle is(Latit, Longit, HeightOfInj). ! In this case, for the upper opening angle, min(Imag(Azimuth), 180.) is used. character *4 Za1ry !1 Specify the primary angle sampling method by one of 'is', 'ps' or 'aps'.\newline ! "is" is isotropic. The range is by CosZenith.\newline ! "ps" is for point source(See also SourceDec)\newline ! "aps" is around point source(See also SourceDec and Ddelta) \newline ! If ObsPlane=3(spherical), this must be "is". real *8 SourceDec !1 Source declination of point source.(deg) real *8 Ddelta !1 SourceDec $\pm$ Ddelta is the region for 'aps'(deg). real *8 HeightOfInj !1 The vertical height of primary injection point(m). ! If this is $<$ deepest obs. level and zeinth angle of primary is $< 0$, ! the primary is assumed to be upgoing even if Reverse=0. ! NOTE:BorderHeightH must be given explicitly in this case. real *8 OffsetHeight !2 The vertical offset height from the deepest detector. ! The primary is directed to this height above the detector. ! If ObsPlane is 3(spherical), not used. !<-) ---------------------------------------------------- common/Zincident/Azimuth
1.8.13